DIY Magnetic Motor (Magnet Generator)

Probably you always wanted to find out what tools and materials will be needed to build a magnetic motor or magnet generator? Here it is-the list at its best!

DIY Magnetic Motor (Magnet Generator)

DIY Magnetic Motor (Magnet Generator)

---

DIY Magnetic Motor (Magnet Generator)

DIY Magnetic Motor (Magnet Generator)

The PMG functions well at low rotational speed. It works towards generating 180 watts at 420 rpm. This is equivalent to 15 amps at 12 volts.

The PMG can easily generate more power at higher speed. However, high currents can be a cause of heated coils which kao3 lv4 the efficiency of the Permanent Magnetic Motor. It would be great to change the stator coils for higher speed. These can be changed via utilizing different size wire or altering the way in which they are connected.

Usage of thicker wire is better for using PMG at higher speeds. Thicker wire is capable of carrying more currentwithout getting excessively heater up.

The wire also results in fewer turns on the coil which indicated that the PMG will not function at low speed.

Changing the connections will let you utilize the same PMG for 10 was well as high speeds. These connections can be changed is two different ways.

List of tools and materials

Fiber glass mat (1 ounce/square foot)-300 grams

Coloring pigMent resin-50 grams

Putty or plasticize Stainless steel wire-200 grams

Grade 3 ferrite magnet (magnetized) blocks- 4000 grams

Enameled wire-winding 3000 grams

Flexible wire Solder & s leaving for connections

Y2 inch masking tape Bridge rectifiers

Heat sink for rectifiers-250 grams

Box section tube(RHS) for spire-1100 grams

Magnet disk or ocTAGonal plates-6000 grams

10 mm threaded rod (studding)-500 grams

10 mm nuts-300 grams

washers 8 mm 10 mm threaded rod-125 grams

8 mm nuts-50 grams

5 mm nuts & both for rectifiers Shaft-500 grams

That is it: not difficult to find these items in ant to build your store magnetic motor- generator.

DIY Magnetic Motor (Magnet Generator)